HORNET engine rebuild
Courtesy Man
Expert Adviser
Some progress on rebuild but first a question: I am ready to align the crank and cam gears to install the timing chain. Is there a way to do this after piston #1 at top dead center and then set cam gear by valve clearance adjustment? Am I making this clear? Otherwise I will be turning cam gear with strap wrench - removing it - trying alignment - over and over. In phot I set up dial indicator on mag base to place piston #1 up. Not much help from shop manual. Gert
0
Comments
-
Another photo - front of Hornet block. Gert
0
Categories
- 37K All Categories
- 119 Hudson 1916 - 1929
- 21 Upcoming Events
- 100 Essex Super 6
- 28.7K HUDSON
- 588 "How To" - Skills, mechanical and other wise
- 995 Street Rods
- 151 American Motors
- 181 The Flathead Forum
- 49 Manuals, etc,.
- 79 Hudson 8
- 44 FORUM - Instructions and Tips on using the forum
- 2.8K CLASSIFIEDS
- 610 Vehicles
- 2.2K Parts & Pieces
- 78 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos