47 Pick up

Unknown
Unknown
edited December 2012 in HUDSON
Does any1 know if a stepdown front end(control arms,springs etc..) will fit the front end of a 47 p/up ? I havent grabbed a tape measure yet to see if control arms are the same length or checked anything,but they appear to be very similar.

Comments

  • Unknown
    Unknown
    I have not done so but just recently someone on the forum here mentioned they had done so.
    Roger
  • Uncle Josh
    Uncle Josh Senior Contributor
    Not sure but I think they used some leftover 47 front ends in the early 48s
  • Unknown
    Unknown
    Finishing my 47 P.U Could use a nice steering wheel I am just new to this sight. I have a stock motor and tranny for the p.u as well as some other parts Thanks John I am in western pa where we like our bibles and guns. Happy New Year
  • Unknown
    Unknown
    For got to leave phone no 724 458 4173 Thanks
  • essexcoupe3131
    essexcoupe3131 Senior Contributor
    Try Rob, if you want a really nice 1
    not sure if he has your year
    http://stepdownplastics.com/44-2/

    Mike
This discussion has been closed.

Categories

In this Discussion